REPLAST Plastic primer
REPLAST plastic primer
REPSYS-PLA-PRIMER-200ML
REPLAST
Register now and access more than 125,000 products
The plastic primer improves the adhesion of REPLAST plastic adhesives on various plastic surfaces.
Carry out preliminary tests to ensure surface compatibility.
The usage instructions are recommendations based on the tests we have conducted and on our experience; we advise conducting your own tests before each application. Due to the wide range of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no liability is assumed in relation to the provision of this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting in bad faith. We guarantee the consistent quality of our products. We reserve the right to make technical changes and further enhance products.
Datasheets(X)
The plastic primer improves the adhesion of REPLAST plastic glue to various plastic surfaces.
Shake well before use. Spray a thin layer of primer onto the prepared parts from a distance of approx. 30 cm and allow them to flash off for at least 5 minutes at 23°C before beginning gluing. Hold the aerosol can in a vertical position. For more information, please refer to the technical data sheet.
Contents | 200 ml |