Paintable ablation coating for use in system C3
The images are examples. For detailed information, other images and documents, please select individual articles from the following table.
Paintable ablation coating for use in system C3
Universally applicable and paintable ablation coating as a protective coating for a wide range of media in the partition system
Show availability in Würth trade store
In order to check the stock in a Würth branch, please log in.
If you have any questions, please call our service hotline at +49 7931 91-0.
You are not yet a Würth customer or do not yet have access data to the Online Shop? Then register now in just a few steps. After a successful check of the entered data, you will have immediate access to the stock inquiry as well as all prices and can immediately order.
Exclusively for trade customers
Register now and access more than 125,000 products
Variants
Exclusively for trade customers
Register now and access more than 125,000 products
- Easy application: by painting, with trowel or airless spraying
- Solvent-free and halogen-free
- Resistant to moisture, for indoor and outdoor use
- Resistant to frost-thaw cycles
- Insensitive to UV radiation
- Resistant to various oils and chemicals
- Free of toxic fumes
- Mechanically resistant
Notice
- Storage: Protect from frost. Storage at room temperature (+5 °C to +30 °C)
- The base material must be dry and free from dust or grease
- Spray processing/airless sprayer: (Nozzle bore
0.019 inch = 0.48 mm), stir with maximum of 2 % addition of water
ETA-17/0105 / Z-19.53-2677
Application area
For use in system [C3]
- Combi AB soft partition
- Use in system C3 as a subsequent coating component of the media/partition surface
- The endothermic, weather-resistant fire protection coating is particularly suitable for large-area and high-build application quantities/layers.
- Apply with brush, roller, joint knife or airless sprayer
- Ideal application at +5 °C to +30 °C and a relative humidity of less than 85 %
- Drying time at least four hours
Instructions
- 1. Clean opening
- 2. Stir the ablation coating to a brushable consistency
- 3. Coat necessary media
- 4. Coat the partition surface/AB pre-coated mineral fibre board
Select RAL-colour code
!! NOTE: On-screen visualisation of the colour differs from real colour shade!!